ELISA Kit for Tetraspanin 30Cluster of Differentiation 63 (CD63)

This assay has high sensitivity and excellent specificity for detection of Tetraspanin 30Cluster of Differentiation 63 (CD63).
No significant cross-reactivity or interference between Tetraspanin 30Cluster of Differentiation 63 (CD63) and analogues was observed.

Matrices listed below were spiked with certain level of recombinant Tetraspanin 30Cluster of Differentiation 63 (CD63) and the recovery rates were calculated by comparing the measured value to the expected amount of Tetraspanin 30Cluster of Differentiation 63 (CD63) in samples.

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Tetraspanin 30Cluster of Differentiation 63 (CD63) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Tetraspanin 30Cluster of Differentiation 63 (CD63) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Tetraspanin 30Cluster of Differentiation 63 (CD63) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.

• ELISA / CLIA Experiment Service

• Single-component Reagents of Assay Kit
• Lysis Buffer Specific for ELISA / CLIA
• Quality Control of Kit
• ELISA Kit Customized Service
• Disease Model Customized Service
• Serums Customized Service
• TGFB1 Activation Reagent
• Real Time PCR Experimental Service
• Streptavidin
• Fast blue Protein Stain solution
• Single-component Reagents of FLIA Kit
• Streptavidin-Agarose Beads